Years of Tracking on One Battery
A sealed, battery-powered tracker for assets with no power of their own. Attach once, stop searching.

A closer look
One sealed device that puts trailers, containers, and idle equipment on your fleet map, no power source required.
IP68 and IP69K sealing shrugs off dust, water immersion, wash-downs, and hard weather.
Magnetic base, adhesive, or screws, so it goes on almost any surface with no wiring.
Built to mount facing open sky, where its GPS and cellular antennas report best, which suits assets that live outdoors.
A sealed battery with nothing to recharge, wire, or swap for its service life.
Rated from -40° to +60°C, so winter laydown yards and summer trailer decks are both in range.
Compact enough to tuck onto a trailer tongue, a container corner, or a generator frame.
Same map, same reports, same login as the rest of your fleet.
What it does
Built for the half of your operation that has no engine to plug into.
Trailers, containers, generators, scissor lifts, portable restrooms, and roll-off bins.
Report on a clock or only when the asset moves, sleeping in between.
Unexpected movement switches it to rapid check-ins until the asset is back.
Messages store on the device outside cellular coverage and send on the next check-in.
One person attaches it, no installer visit.

On The Same Map
Every report lands on the map with a last-seen location and movement history per asset.
In Your Reports
Utilization rolls up per asset, so the trailer that never moves stops hiding.

If It Rolls, Tows, Lifts, or Sits
Battery-powered and self-contained, GO Anywhere goes on the assets a wired tracker never could.














GO AnywhereOne battery-powered tracker for all of it. No wiring, no power source, years of battery life.
Rain, mud, and wash-downs
The sealed housing means the tracker survives whatever the asset does.
If it sits outdoors and has no power, this is its tracker.
IP69K sealing takes high-pressure, high-temperature wash-downs.
A sealed battery rated for up to 10 years outlasts most deployments.
On the device
Charge, fault status, and check-in schedule, at a glance.

GO Anywhere or GO Anywhere Plus
The asset has no power, lives outdoors, and sits in areas with cellular coverage. Its battery-only design and check-in modes are built exactly for that: attach it, pick a reporting rate, and forget it is there.
The asset is wired, higher-value, or travels past the edge of cell coverage. The Plus adds powered near-real-time reporting, engine hours, and Starlink Direct-to-Cell satellite backup.
We map trackers to your actual asset list, not a brochure. Talk through your assets and we will spec it with you.
Questions
GO Anywhere delivers up to 10 years of battery life depending on usage and reporting mode. It supports configurable time-based or movement-based tracking with a smart sleep mode, plus a high-frequency mode for theft recovery. We set the reporting rate with you to balance battery life and visibility.
Attach it to the asset with the magnetic base, adhesive, or screws. No wiring, charging, or tools. A quick wave of a magnet confirms it is working.
If it moves unexpectedly, the tracker automatically speeds up to frequent updates so you can recover it fast, then returns to normal to preserve battery.
It reports over the cellular network wherever there is coverage and stores messages to send at the next check-in. For assets that travel truly off the grid, GO Anywhere Plus adds satellite backup.
Keep exploring
We ship a free demo tracker to your door. Attach it to a trailer and watch it report. A named specialist walks you through the rest. No obligation.